Elegoo enters the filament dryer market with the 85C H1 HT

A first for Elegoo

Elegoo built its name on affordable 3D printers and resin machines. On July 24, 2026, the company stepped into a new category with the H1 HT Filament Dryer, its first product of this kind. The pitch is simple: dry filament hot enough to matter, and do it for everyone, not just labs with industrial prep stations.

The number that counts: 85C

Most consumer dryers top out around 50 to 55C. That is fine for PLA and PETG but useless for the materials that actually suffer from moisture, the engineering filaments such as PA (nylon) and PC (polycarbonate) that print best only after a serious bake. The H1 HT reaches up to 85C, which Elegoo positions as among the highest in its class.

Heat alone is not enough. The H1 HT adds active dehumidification with two automatic vents that push humid air out of the chamber while drying, then seal shut when the cycle ends so the spool does not soak moisture back up. A motor also rotates the spool during the cycle for even drying, a small touch that stops one side of the filament from staying damp.

Easy to run

There is a 3.5 inch color touchscreen on the front, with 11 preset modes for common materials and a manual mode for people who want to set their own time and temperature. Elegoo says the unit works with essentially any FDM printer and any brand of filament, so there is no lock in on either side.

Safety and price

Because it runs hot, Elegoo loaded the H1 HT with safety features: overheat protection, a flame resistant inner shell, lid open detection, fan fault detection, and audible alerts if something goes wrong. The dryer sells for about 70 dollars in the US, 70 euros in the EU, 62 pounds in the UK, and 90 Canadian dollars.

For makers who keep fighting popped bubbles, weak layer adhesion, and mysterious print failures, the H1 HT is a reminder that the problem is often the spool, not the printer. Drying at 85C puts PA and PC within reach of a weekend project instead of a professional setup.